Argoms' Blog
Monday, 13 October 2014
Precocking proof of concept
Near instant trigger response with 18:1 gears and a 7.4v lipo.
I know I'm probably not the first to do this, but this is how I did it.
Sunday, 5 October 2014
SHS M4 receiver review
Yeah, SHS makes M4 receivers. I didn't know until recently either.
This receiver is available from ak2m4.co.uk for £40. It comes packaged in a simple cardboard box with a sheet of dense foam on either side. Nothing fancy, but definitely enough to protect the thing.
This receiver is available from ak2m4.co.uk for £40. It comes packaged in a simple cardboard box with a sheet of dense foam on either side. Nothing fancy, but definitely enough to protect the thing.
Monday, 29 September 2014
VSR wrench
For those of you who have access to 3D printers, here's a design for a VSR wrench. Needs two M3 screws. Could probably laser cut it too, I guess.
Would recommend painting with ABS slurry (if printing in ABS) or the layers may de-laminate when used on tightly fitting cylinder heads.
Would recommend painting with ABS slurry (if printing in ABS) or the layers may de-laminate when used on tightly fitting cylinder heads.
Saturday, 27 September 2014
G36KV stock cheek riser
This was my G36:
Looks good, but it has actually been very uncomfortable to shoot ever since I put the scope on it because the stock cheek rest isn't high enough. Here's my solution:
Looks good, but it has actually been very uncomfortable to shoot ever since I put the scope on it because the stock cheek rest isn't high enough. Here's my solution:
Sunday, 14 September 2014
HFC VSR stock performance review
Monday, 18 August 2014
ZCI/SHS piston comparison
Saturday, 2 August 2014
G36 large handguard
Subscribe to:
Posts (Atom)